Code Search

Please fill the "Code Box" to find engine fault code.

Car Models :

Please select your car.

How To Clear Check Engine Lights ?

Ways to clear check engine light on car panel.

Check Engine Light Dictionary

Ways to clear check engine light on car panel.

U0300 Engine Trouble Code

Meaning of U0300 engine trouble code is a kind of network trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

U0300 Fault Symptoms :

Check engine light comes on
Engine stalling or misfiring
Engine performance issues
Car not starting

If one of these reasons for U0300 code is occuring now you should check U0300 repair processes.
Now don't ask yourself; What should you do with U0300 code ?
The solution is here :

U0300 Possible Solution:

Power Steering Pressure (PSP) Switch Malfunction In Key On, Engine Off Self-Test, this DTC indicates the PSP input to the PCM is high. In Key On, Engine Running Self-Test, this DTC indicates that the PSP input did not change state. Steering wheel must be turned during Key On, Engine Running Self-Test PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged.

U0300 Code Meaning :

U	0	3	0	0
OBD-II Diagnostic Network (U) Trouble Code For Engine	Intake Valve Control Solenoid Circuit Low	Throttle/Pedal Position Sensor/Switch A Circuit Intermittent	Cold Start Injector 1 Malfunction	Shift Solenoid E Performance or Stuck Off

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

U0300 OBD-II Diagnostic Network (U) Trouble Code Description

U0300 engine trouble code is about Shift Solenoid E Performance or Stuck Off.

Main reason For U0300 Code

The reason of U0300 OBD-II Engine Trouble Code is Throttle/Pedal Position Sensor/Switch A Circuit Intermittent.

U0300 DTC specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.

	Example: 0140